How Much Do You Know About Hedging Hole Nets?

- Dec 04, 2018-

Speaking of punching nets, I think everyone will be stranger, because in different regions, it has unused names. In the north, especially in the area where punching nets are produced, people used to call it a punching net because of the production process. In some southern countries, it is called a perforated plate or a hole plate. It is really a very famous name.

Because of the different uses, people call it a variety of things. Go to the hotel to eat and see the punching net hanging on the wall of the room. At this time, its new name is the decorative net. When it is used for filtering, it is called a filter. Did you see it on the headphones or on the stereo? At this time, you should call it audio network, headphone network. According to other uses, people will call it sound-absorbing panels, climbing nets, protective nets, etc.

According to the shape of the hole, people have given it a new name. The hole type is round, which is called a round hole net; the hole type is square, called square hole plate net. There are also other hole types, such as rectangular holes, rhombic holes, hexagonal holes, cross holes, triangular holes, oblong holes, long waist holes, plum holes, fish scale holes, pattern holes, pentagonal holes, irregular holes. , from the drum hole and so on.

Of course, in the process of punching, it is not so smooth, and some deviations will occur. So what are the deviations? What is the corrective method? Please look down!

(1) Correction of eccentricity during punching: When the punching is uneven due to the uneven surface of the anvil, the skew at both ends of the punch, and the uneven heating of the billet, the aperture eccentricity is generated. The method of correction can be carried out by the immersion method: when the operation is performed, the thin side of the hole wall is immersed in water to lower the temperature, and then the hole is reamed by the punch, and the wall thickness is thinned due to the higher temperature and the plasticity, so that the entire forging wall The thickness is even and the eccentricity is corrected. This method is suitable for materials with good plasticity.

(2) The blank is out of shape when punching. That is, the metal under the punch is pushed to the periphery, the height of the blank is reduced, the diameter is increased, the upper end surface is recessed, and the lower end surface is convex. The degree of the sample is related to the size of the blank diameter D0, the height H0 and the aperture d1 before punching. The smaller the D0/d1 is, the more serious the degree of aliasing is. The corrective method is: D0/d1≥2.5~3 should be controlled as well. If the diameter of the punched hole is large, such as D0/dl<2.5, the hole is generally punched first, and then the hole is expanded to obtain the required hole diameter.